Today xiaobian for you to explain the common faults and solutions of the end sealing filling machine, so that you can use the filling machine more smoothly.

1. Excessive melting: usually caused by excessive temperature, it should be checked whether the actual temperature is in line with the temperature required by the normal operation of the hose;

2, the end of the uneven: can be sealed by the two tubes, left and right cross height, such as the occurrence of left and right, it is necessary to adjust the balance of the fixed position of the heating head;

3. There are ears on one side: first check whether the position of the heating head is correct, and then check the verticality of the heating head and the hose below; Or observe whether there is a deviation in the parallelism of the two tail plate, such as through a gasket between 0.2 and 0.3 mm to detect;

4. The end seal starts to split in the middle of the hose: the size of the heating head may be insufficient, so the heating head of a larger size needs to be replaced. The size of the heating head is determined by inserting the heating head into the hose and pulling it out. Slight suction is felt when pulling out.

5, the end of the "pouch" : can be adjusted to increase the height of the heating head mechanism.

    The above list is only a few common sealing problems, if you have more questions, please contact us. Hubei Greatxing intelligent technology Co., Ltd. specializes in the production of diagnostic reagent filling machine, liquid filling machine, paste filling machine, powder filling machine, automatic filling machine and other products.